How do you migrate a project integrated in STEP 7 from WinCC flexible to WinCC (TIA Portal)?
Migration of an MP
277 Touch operator panel integrated in STEP 7 V5.x to a WinCC (TIA
Portal) project and then device replacement with a Comfort Panel.
For a subsequent plant/machine only the MP 277 Touch configuration described is to be migrated to WinCC (TIA Portal) and replaced by a Comfort Panel.
DescriptionThis entry shows one option for migrating only the WinCC flexible project to WinCC (TIA Portal).
A description is given of the separate steps for migrating the multipanel to WinCC (TIA Portal).
This is followed by a description of how to change the MP 277 Touch configuration into a Comfort Panel.
Contents of the PDF document
The following points are covered in the document:
- Software requirements
- Copy integrated HMI project from STEP 7 V5.x
- Migrate HMI project to WinCC (TIA Portal)
- Replacing MP 277 Touch with a Comfort Panel
Migration in WinCC V15 (1,4 MB)
Documentation, WinCC (TIA Portal) V14
Migration in WinCC V14 (748.2 KB)
Further Information
Topic |
Entry ID
|
---|---|
Shared configuration with WinCC (TIA Portal) and STEP 7 V5.x | 73502293 |
Migration of a WinCC flexible project integrated in STEP 7 V5.x to WinCC (TIA Portal) and upgrading of the operator panel version after a change of the WinCC (TIA Portal) version to a newer version. | 77430539 |
Overview of the Mounting Positions, Screen Diagonals and Resolutions of Panels | 56076296 |
SIMATIC HMI Operator Panels Migration Guide for Comfort Panels | 49752044 |
System Manual WinCC Comfort / WinCC Advanced | 91479053 |
Additional Keywords
Convert, Apply, Integrate, Change, Update
0 comments:
Post a Comment